TM 5-3895-371-24 & P
b.
Installation. ( Refer to fig. 3-115.)
(1)
On the left side, lift tank into position over chassis frame with suitable hoist; aline
mounts and holes; set in place.
(2)
Install four tank to sub-frame bolts (1, fig. 4-11).
(3)
Install four bolts with springs securing tank to frame. Tighten nuts until it just touches
spring top then pull down one inch (fig. 3-105).
(4)
Install eight bolts through walkway and brackets (para 4-6).
(5)
Install wire loom to tank (para 2-10).
(6)
Install wire loom to lower cab corner (fig. 3-114).
(7)
Install bell assembly (para 2-12).
Figure 3-115. Support Tank with Sling and Hoist
TA 075988
3-99