TM 5-3895-371-24 & P
(24)
Apply Vaseline to new O-ring (23) and position on the pump cover (21). Fill pistons
with new transmission oil allowing a small excess oil to spill over the face of the block assembly (30).
(25)
Place new cover gasket (22) on housing and position cover as shown in figure 3-45
utilizing reference marks in housing and cover. To operate properly, the cover must be assembled in
its original position. Install two short capscrews (35, fig. 3-4), four long capscrews (19), and six lock-
washers (20). Torque capscrews opposite one another to 40 Ib-ft (54 Nm) until all six capscrews are
tight.
Figure 3-45. Installing Pump Cover.
oil.
(26)
Position bearing (13). Lubricate the entire charge pump cavity with clean transmission
(27)
Install valve plate (10, fig. 3-46) over bearing (13, fig. 34). Install on to shaft assembly
pump shaft (53).
Figure 3-46. Charge Pump Lower Valve Plate.
3-40