TM 5-3895-371-24 & P
Lift housing (5) from pump housing, breaking the seal with gasket (9). Care should be
taken to avoid bending the valve sleeve assembly (11) by swinging it to one side, as illustrated in figure
3-11 before proceeding to step (4). Remove O-ring (10, fig. 3-10).
Figure 3-11. Cam Actuator Arm and Valve Sleeve.
A clean shop rag should be positioned around the cam
arm to prevent the loss of the retaining ring into the
control housing (5). (Refer to fig. 3-12.)
With a small screwdriver, remove retaining ring (29) from the side of the cam arm oppo-
site the counterbore.
Remove clevis pin (28, fig. 3-10) with second retaining ring and slip the control link
part of plunger assembly (30)) from the cam lever. Remove gasket (9) from control housing.
Figure 3-12. Removing Retaining Ring.