TM 5-3895-371-24 & P
(6) Lubricate the entire inner surface of cylinder tube (26) with clean transmission oil.
Install tube (261 over piston assembly (27) and seat tube (26) against housing (5). (Refer to fig. 3-53.)
Figure 3-53. Cylinder with Servo Plunger.
(7) Install two new
O-rings (33, fig. 3-54)
on each end
of transfer tube (34). Lubricate the
ends of transfer tube (34) and insert in cylinder cover (22). Install cylinder cover (22) with new O-ring
(20) and transfer tube over studs (21) and seat into end of tube (26). Care must be taken not to damage
transfer tube O-ring (33) as the transfer tube (34) is being positioned in housing (5). Install four lock-,
washers (24) and hex nuts (23) on studs (21) and torque. to 6 Ib-ft (8 Nm). Care should be taken to
torque the hex nuts (23) gradually and in sequence to insure proper seating of the cylinder cover (22)
and to minimize the possibility of twisting a stud to the breaking point.
Figure 3-54. Cylinder Cover with Transfer Tube.