TM 5-3895-371-24 & P
Disconnect lanyard at bell by loosening screw (1); then pull old lanyard out of vehicle.
Disconnect fitting on lanyard tube, located near the tank manhole cover.
Pass new lanyard cord up through tube from rear of vehicle.
Connect lanyard to bell actuating arm (6) and secure with screw (1).
Connect fitting on lanyard tube (removed in step (2).
(6) Check operation of bell.
Section IX. MAINTENANCE OF HAND SPRAY GUN ASSEMBLY
2-13. Hand Spray Gun Assembly.
Removal. (Refer to fig. 2-7).
To remove the hand spray gun tube assembly, lift
two retaining clamps on vehicle.
Remove/lnstall Hand Spray Gun.