Disconnect pump off line.
Turn vacu-flo lever straight up to normal position
To blow out hand spray, if desired after spraying, raise intake valve lever, remove filling cap, open hand
spraying valve and push butterfly valve lever in against stop. Add flushing oil if desired.
Reinstall filling cap.
Place the control levers (see fig. 2-9 for location) in the following positions
Quadrant Control Lever - Hand spray
Butterfly Valve Lever - In
Intake Valve Lever - Up
Bar Raising Lever - Up
Transfer Valve Lever - Hand spray
Drain Valve Lever - Forward
Vacu-flo Valve Lever - Up
Hook up hose from supply source to the filling connection using filling line adapter from tool box. Be sure
connections are tight.
Hook up hose from storage to transfer connection using adapter from tool box. Be sure connections are
Run pump at maximum speed where it will run quietly Normally 150 gpm is best transfer speed.
When through transferring, turn transfer valve lever to Distribute position. Pull butterfly valve lever back
out against stop.
If oil enters distributor tank when transferring, butterfly value is not closed tight.