LO 5-3895-215-12
*-KEY -
EXPECTED TEMPERATURES
Above +15 F
+ 40 F to -15 F
+40 F to -65 F
CAPACITY
INTERVALS
(Above -9 )
(+ 4 to -26 )
(+4 to -54 )
OE/
-
Lubricating
OE/HDO 30
OE/HDO 10
HDO
Oil, Internal
Engine, Tac-
tical Service
OEA
-
Lubricating
OEA
Intervals
Oil, Internal
given are
Arctic
-
Oil Can
in hours
Points
-
Gear
of normal
Reduction
operation.
GRG -
Grease, Plug
ALL TEMPERATURES
Valve, Gaso-
line and Oil
Resistant
GAA - Grease,
Automotive
ALL TEMPERATURES
and Artillery
*See Note 4 for lubricant specification number.
NOTES:
applicable specification numbers.
1.
FOR OPERATION OF EQUIPMENT in
PROTRACTED COLD TEMPERATURES BELOW
OE/HDO
MIL-L-2104
-15F(-26C). Remove lubricants prescribed in Key for
GAA
MIL-G-10924
OEA
MIL-L-46167
temperatures above -150F (-26C). Relubricate with
GRG
MIL-G-6032
lubricants specified in Key for temperatures below -15 F
(SD), Type II
P-D-680
(-26C).
If OEA lubricant is required to meet the
temperature ranges prescribed in the Key, OEA lubricant
Copy of this Lubrication Order will remain with the
is to be used in place of OE/HDO-10 lubricant for all
equipment at all times, instructions contained herein are
temperature ranges where OE/HDO-10 is specified in
mandatory.
By order of the Secretary of the Army:
2. OIL CAN POINTS. Each 50 hours lubricate control
JOHN A. WICKHAM, JR.
linkage, pins and clevises, and all exposed adjusting
General, United States Army
threads with OE/HDO.
Chief of Staff
OFFICIAL:
3. WHEEL BEARINGS. Each 1000 hours remove
ROBERT M. JOYCE
wheels, clean and inspect all parts, replace worn or
Major General, United States Army
damaged parts, repack bearings, and reassemble.
The Adjutant General
DISTRIBUTION:
4. LUBRICANTS. The following is a list of lubricants
To be distributed in accordance with DA Form 12-25B,
with military symbols and
Operator and Organizational maintenance requirements
TA 219639
CARD 3 OF 3